Abrasives choice of sand belt
-- usually the workpiece material with high tensile strength, high toughness are selected high pressure bearing, strong crushing resistance, high temperature resistance and chemical aluminium oxide abrasives ;
-- metal and non-metal workpieces with low tensile strength and high toughness, and silicon carbide abrasive materials with high hardness, high brittleness and easy to be broken, such as glass, brass, leather, rubber, ceramics, jade, particleboard, fiberboard, etc.
sand belt for metal,2x42 sanding belt,aluminium oxide sand belt,silicon carbide abrasive belt
Treatment of sand belt before use:
When the sand belt is used, the direction of operation should be consistent with the direction marked on the back of the belt, so as to avoid the belt from breaking in operation or affecting the surface quality of the workpiece in the processing plant. The grinding belt should be rotated for a few minutes before grinding, and the grinding will be started when the belt is in normal operation.
The sand belt should be suspended before use. The sanding belt to be unpacked should be suspended on the 100-250mm diameter pipe 2 ~ 3 days. The selection of pipe diameter should be based on the size of the sand belt. When suspended, the joint should be at the top of the pipe and the pipe should be in a horizontal state.
Yihong abrasives | Sanders flap disc | Sanders flap wheel | Sanders abrasive belt
Flap Wheel | Abrasive Belt | Raw Material | Flap Wheel with Shank
Copyright ©Henan Sanders Abrasives Co.,Ltd All Rights Reserved. Technical Support By Yihong Century Network Technology Co., Ltd. Sitemap